Liteguide Controller AE1000 Nireco vietnam-Bộ điều khiển khuếch đại AE500

Xuất Xứ:

Japan

Chia sẻ:

Số lượng

Specifications

Power Supply Voltage		AC100 to 240V 50/60Hz ±10%
Power Consumption		300 VA (inrush current 100 A 10 ms typical (200 V))
Power Fuse		250V AC, 3.15 A (time-lag type)
Ambient Operating Temperature		0 to 50°C
Ambient Operating Humidity		35 to 85% RH or lower (no condensation)
Vibration Resistance		3.5 mm, 1 G, 3 to 150 Hz, three-directions (1hour)
Power supply Noise		2.5 kVp-p, normal mode, common mode 50 ns, 1μs width
Usage atmosphere:		Area with no water, flammable or corrosive gases, and little dust.
Mass		Approximately 5 kg
IP Class		IP30
Input	2 Sensor systems	Voltage input Maximum ±5V（No input resistance） Current input 0-20mA (input resistance converted to 240/2kΩ)
	2 analog shift systems	Voltage input Maximum ±10V
	Centering	Proximity switch input （0-8V, 1.2kΩ input resistance）（Applies to: KL1632. 0-90P）
	Position Transmitter	Voltage input Maximum ±10V
	Photo coupler input （12V DC, 15mA）	Remote controller : Operation mode switching（auto / manual / centering） Operation keys （left / right / auto balance / reverse） System selection（EPC1 / EPC2） Locks 3 points Actuator end limit : 2 points
Output	Electrical actuator	K12 ±24V DC, 1A(maximum) or K62 ±36V DC, 2A(maximum)
	Lamp power source	4 to 12V DC, variable （maximum 1A）
	Fine tuner, Position transmitter, LH8B	±5V power source （maximum 0.1A）
	Sensors	±15V power source （+15V, 1A; -15V, 0.2A）（Note: The current capacity on the + side combined with the lamp power source in(2) is less than 1A.）
	Centering proximity switch power source	8V DC （maximum 30mA）
	2 indicator systems	Voltage output Maximum ±10V （load resistance 2kΩ or greater） Deviation output Position transmitter output
	Photo coupler output （24V DC, 40mA）	Remote controller : Operation mode state（auto / manual / centering） System state （EPC1 / EPC2） Alarms Excessive deviation End limit Actuator lock Actuator excessive load